Rockwell Automation 1768-L43 - Mount and Wire the Powerflex 70 Drive

Publication IASIMP-QS003B-EN-P - October 2009 63
Prepare the PowerFlex 70 Drive Chapter 4
Mount and Wire the PowerFlex 70 Drive
Required for EtherNet/IP and DeviceNet Systems
1. Mount the PowerFlex 70
drive to the control
enclosure subpanel using
the four mounting slots
provided.
For mounting
instructions, refer to the
PowerFlex 70 User
Manual, publication
20A-UM001.
2. Loosen the screw and
remove the cover.
WARNING
Verify that all incoming power is turned off before wiring power.