Rockwell Automation 1768-L43 - Chapter 8: Configure the DeviceNet Network; Introduction; Before You Begin; What You Need

93Publication IASIMP-QS003B-EN-P - October 2009 93
Chapter 8
Configure the DeviceNet Network
Introduction
In this chapter, you configure the DeviceNet node address for the 1769-SDN module. You
also create the RSNetWorx for DeviceNet file that stores the network configuration.
Before You Begin
• Install all hardware, including the DeviceNet Scanner (Chapter 1 through 6).
• Prepare the computer (Chapter 2
).
• Connect devices to the DeviceNet network (option 1).
– POINT I/O 1734-ADN DeviceNet adapter (Chapter 3
)
– PowerFlex 70 drive with 20-COMM-D adapter (Chapter 4
)
• Verify that power is applied to all devices.
What You Need
• RSNetWorx for DeviceNet software