Rockwell Automation 1768-L43 - Test the Application on the Panelview Plus Terminal

Publication IASIMP-QS003B-EN-P - October 2009 181
Create a PanelView Plus Application Chapter 12
Test the Application on the PanelView Plus Terminal
1. On the PanelView Plus
terminal, press the Load
Application [F1].
2. Select your .mer file and
press Load [F2].
3. Press Yes [F7].
4. After the application
loads, press Run
Application [F2].
5. Press the push button
and verify that the
indicator turns on and
that the light on the
Compact digital output
module turns on.
6. Press the push button
again and verify that the
indicator and light turn
off.