FSE CALCulate Subsystem
1065.6016.12 6.55 E-16
:CALCulate<1|2>:MARKer<1 to 4>:FUNCtion:SUMMary:MPEak[:STATe] ON | OFF
This command switches on or off the measurement of the negative peak value.
Example: ":CALC:MARK:FUNC:SUMM:MPE ON"
Features: *RST value: OFF
SCPI: device-specific
Mode: VA
When the measurement is switched on, the summary marker is automatically activated (command
SUMMary:STATe set to ON). When it is switched off, the summary marker remains switched on
provided further measurements are selected. Otherwise the marker is switched off automatically.
:CALCulate<1|2>:MARKer<1 to 4>:FUNCtion:SUMMary:MPEak:RESult?
This command queries the result of the measurement of the negative peak value. Results of average
calculation and peak hold are queried with commands
...:MPEak:AVERage:RESult? and
...:MPEak:PHOLd:RESult?.
Example: ":CALC:MARK:FUNC:SUMM:MPE:RES?"
Features: *RST- value: -
SCPI: device-specific
Mode: VA
This command is only a query and thus has no *RST value assigned.
:CALCulate<1|2>:MARKer<1 to 4>:FUNCtion:SUMMary:MPEak:AVERage:RESult?
This command queries the result of the measurement of the negative peak value if the average is
calculated using the command
:CALCulate<1|2>:MARKer<1 to 4>:FUNCtion:
SUMMary:AVERage
.
Example: ":CALC:MARK:FUNC:SUMM:MPE:AVER:RES?"
Features: *RST- value: -
SCPI: device-specific
Mode: VA
This command is only a query and thus has no *RST value assigned.
:CALCulate<1|2>:MARKer<1 to 4>:FUNCtion:SUMMary:MPEak:PHOLd:RESult?
This command queries the result of the measurement of the negative peak value if the peak hold
function is switched on with command
:CALCulate<1|2>:MARKer<1 to 4>:
FUNCtion:SUMMary:PHOLd
.
Example: ":CALC:MARK:FUNC:SUMM:MPE:RES?"
Features: *RST- value: -
SCPI: device-specific
Mode: VA
This command is only a query and thus has no *RST value assigned.
To Next Page
Loading...
