FSE CALCulate Subsystem
1065.6016.12 6.57 E-16
:CALCulate<1|2>:MARKer<1 to 4>:FUNCtion:SUMMary:RMS[:STATe] ON | OFF
This command switches on or off the measurement of the effective (rms) value of the total trace.
Example: ":CALC:MARK:FUNC:SUM:RMS ON"
Features: *RST value: OFF
SCPI: device-specific
Modes: A-Z, VA
When the measurement is switched on, the summary marker is automatically activated (command
SUMMary:STATe set to ON). When it is switched off, the summary marker remains switched on
provided further measurements are selected. Otherwise the marker is switched off automatically.
:CALCulate<1|2>:MARKer<1 to 4>:FUNCtion:SUMMary:RMS:RESult?
This command queries the result of the measurement of the mean value of the total trace. Results of
average calculation and peak hold are queried with commands
...:RMS:AVERage:RESult? and
...:RMS:PHOLd:RESult?..
Example: ":CALC:MARK:FUNC:SUMM:RMS:RES?"
Features: *RST- value: -
SCPI: device-specific
Modes: A-Z, VA
This command is only a query and thus has no *RST value assigned.
:CALCulate<1|2>:MARKer<1 to 4>:FUNCtion:SUMMary:RMS:AVERage:RESult?
This command queries the result of the measurement of the mean value of the total trace if the
average is calculated using the command
:CALCulate<1|2>:MARKer<1 to 4>:FUNCtion:
SUMMary:AVERage
.
Example: ":CALC:MARK:FUNC:SUMM:RMS:AVER:RES?"
Features: *RST- value: -
SCPI: device-specific
Modes: A-Z, VA
This command is only a query and thus has no *RST value assigned.
:CALCulate<1|2>:MARKer<1 to 4>:FUNCtion:SUMMary:RMS:PHOLd:RESult?
This command queries the result of the measurement of the mean value of the total trace if the peak
hold function is switched on using the command
:CALCulate<1|2>:MARKer<1 to 4>:
FUNCtion:SUMMary:PHOLd
.
Example: ":CALC:MARK:FUNC:SUMM:RMS:PHOL:RES?"
Features: *RST- value: -
SCPI: device-specific
Modes: A-Z, VA
This command is only a query and thus has no *RST value assigned.
To Next Page
Loading...
