Rohde & Schwarz FSEA20 - Page 122

FSE CONFigure-Subsystem
1065.6016.12 6.65 E-16
CONFigure Subsystem
The CONFigure subsystem contains commands for configuring complex measurement tasks, like those
provided by the options GSM BTS Analyzer (FSE-K11) or GSM MS Analyzer (FSE-K10). The
CONFigure subsystem is closely linked to the functions of the FETCH and READ subsystems, where
the measurement cycles are started and/or the results of the measurements are queried.
CONFigure:BTS Subsystem
This subsystem provides the commands for configuring the GSM BTS Analyzer mode (Option FSE-K11)
for analyzing the behavior of base stations corresponding to the standards P-GSM, E-GSM, R-GSM,
DCS1800 or PCS1900. EDGE measurement require option FSE-K21, and tests in the GSM 850 MHz
band option FSE-K31.
COMMAND PARAMETERS UNIT COMMENT
CONFigure
[:BTS]
:MEASurement?
:ARFCn
:AUTO
:LIMit
:PPEak
:PRMS
:EVMRms
:EVMPeak
:OSUPpress
:PERCentile
:FREQuency
:STANdard
:POWer
:CLASs
:COUPled
:STATic
:DYNamic
:EXPected
:LIMit
:SINGle
[:STATe]
:CLEar
:CHANnel
:SLOT
:AUTO
:TSC
:AUTO
:SFH
:NETWork
[:TYPE]
:PHASe
:COSiting
:TXSupp
:PRESet
:SWEeptime
:MTYPe
:STYPe
<numeric_value>
ONCE
<numeric_value>
<numeric_value>
<numeric_value>
<numeric_value>
<numeric_value>
<numeric_value>
<numeric_value>
<Boolean>
<numeric_value> | M1 | M2 | M3 | P1 |
EG1 | EG2 | EG3
<Boolean>
<numeric_value>
<numeric_value>
<numeric_value>
<numeric_value>
<Boolean>
--
<numeric_value>
ONCE
<numeric_value>
<Boolean>
<Boolean>
PGSM | PGSM900| EGSM |
EGSM900 | DCS | GSM1800 |
PCS | GSM1900 | RGSM |
RGSM900 | GSM850
1|2[,PLUS]
<Boolean>
<Boolean>
--
STANdard | AUTO
GMSK | EDGE
NORMal | MICRo | PICO
--
DEG
DEG
PCT
PCT
DB
PCT
ppm
--
--
--
DBM
DBM
--
--
Option FSE-K11/K21/31
query only
no query
no query
no query
no query
no query