CONFigure-Subsystem FSE
1065.6016.12 6.74 E-16
:CONFigure:BURSt:PFERror:CONDition NORMal | EXTReme
This command defines the conditions for phase-frequency measurement.
Example: ":CONF:BURS:PFER:COND EXTR"
Features: *RST value: NORMal
SCPI: device-specific
Modes: BTS, MS
:CONFigure:BURSt:MACCuracy[:IMMediate]
This command selects measurement of the measurement accuracy of the base station or mobile.
Example: ":CONF:BURS:MACC"
Features: *RST value: --
SCPI: device-specific
Modes: BTS, MS
This command is an event and thus has no query and no *RST value assigned.
It is available only in conjunction with option GSM BTS Analyzer FSE-K11 or option GSM MS
Analyzer, FSE-K10, and Vector Signal Analysis, FSE-B7.
:CONFigure:BURSt:MACCuracy:COUNt 1 to 1000
This command sets the number of bursts used for the determination of average and maximum value.
Example: ":CONF:BURS:MACC:COUN 100"
Features: *RST value: 1
SCPI: device-specific
Modes:BTS, MS
It is available only in conjunction with option GSM BTS Analyzer FSE-K11 or option GSM MS
Analyzer, FSE-K10, and Vector Signal Analysis, FSE-B7.
:CONFigure:BURSt:MACCuracy:CONDition NORMal | EXTReme
This command defines the conditions for modulation accuracy measurement.
Example: ":CONF:BURS:MACC:COND EXTR"
Features: *RST value: NORMal
SCPI: device-specific
Modes: BTS, MS
To Next Page
Loading...
