FSE FETCh-Subsystem
1065.6016.12 6.103 E-16
:FETCh:BURSt:PERRor:PEAK:STATus?
This command reads out the status of the peak measurement of the phase error taken over the
selected number of bursts.
0: failed, 1: passed
Example: ":FETC:BURS:PERR:PEAK:STAT?"
Features: *RST value --
SCPI: device-specific
Modes: BTS, MS
If no measurement has been performed yet, a query error results.
This command is a query only and therefore has no *RST value assigned. It is available only if
measurement of the phase/frequency error is selected (see :CONFigure:BURSt:PFERror).
:FETCh:BURSt:PERRor:PEAK:AVERage?
This command reads out the average of the peak measurement of the phase error taken over the
selected number of bursts.
Example: ":FETC:BURS:PERR:PEAK:AVER?"
Features: *RST value: --
SCPI: device-specific
Modes: BTS, MS
If no measurement has been performed yet, a query error results.
This command is a query only and therefore has no *RST value assigned. It is available only if
measurement of the phase/frequency error is selected (see :CONFigure:BURSt:PFERror).
:FETCh:BURSt:PERRor:PEAK:MAXimum?
This command reads out the maximum of the peak measurement of the phase error for the selected
number of bursts.
Example: ":FETC:BURS:PERR:PEAK:MAX?"
Features: *RST value: --
SCPI: device-specific
Modes: BTS, MS
If no measurement has been performed yet, a query error results.
This command is a query only and therefore has no *RST value assigned. It is available only when
measurement of the phase/frequency error is selected (see :CONFigure:BURSt:PFERror).
To Next Page
Loading...
