FETCh-Subsystem FSE
1065.6016.12 6.104 E-16
:FETCh:BURSt:FERRor:STATus?
This command reads out the status of the measurement of the frequency error taken over the
selected number of bursts.
0: failed, 1: passed
Example: ":FETC:BURS:FERR:STAT?"
Features: *RST value: --
SCPI: device specific
Modes: BTS, MS
If no measurement has been performed yet, a query error results.
This command is a query only and therefore has no *RST value assigned. It is available only if
measurement of the phase/frequency error is selected (see :CONFigure:BURSt:PFERror).
:FETCh:BURSt:FERRor:AVERage?
This command reads out the average of the measurement of the frequency error taken over the
selected number of bursts.
Example: ":FETC:BURS:FERR:AVER?"
Features: *RST value: --
SCPI: device-specific
Modes: BTS, MS
If no measurement has been performed yet, a query error results.
This command is a query only and therefore has no *RST value assigned. It is available only if
measurement of the phase/frequency error is selected (see :CONFigure:BURSt:PFERror).
:FETCh:BURSt:FERRor:MAXimum?
This command reads out the maximum frequency error measured over the selected number of
bursts.
Example: ":FETC:BURS:FERR:MAX?"
Features: *RST value: --
SCPI: device-specific
Modes: BTS, MS
If no measurement has been performed yet, a query error results.
This command is a query only and therefore has no *RST value assigned. It is available only if
measurement of the phase/frequency error is selected (see :CONFigure:BURSt:PFERror).
To Next Page
Loading...
