FSE FETCh-Subsystem
1065.6016.12 6.111 E-16
FETCh:PTEMplate Subsystem
This subsystem provides the commands for reading out results of measurements in the GSM BTS
(FSE-K11) or GSM MS (FSE-K10) Analyzer mode which are used to determine the carrier power of ,
power versus time measurement without first restarting a new measurement.
Command Parameter Unit Comment
FETCh Option FSE-K11, FSE-K10
:PTEMplate
:REFerence? query only
:FETCh:PTEMplate:REFerence?
This command reads out the results of the premeasurement
Parameter: The result is output as a list of partial result strings separated by ’,’ in the following
(ASCII) format:
<Level1>,<Level2>,<RBW>
<Level1>: measured level
<Level2>: level corrected by means of the bandwidth
<RBW>: bandwidth
Example: ":FETC:PTEM:REF?"
Result: 43.2,43.2,1000000
Features: *RST value: --
SCPI: devicespecific
Modes: BTS, MS
If no measurement has been performed yet, a query error results.
This command is a query only and therefore has no *RST value assigned. It is available only if
measurement of Power versus Time is selected (see :CONFigure:BURSt:PTEMplate).
To Next Page
Loading...
