FETCh-Subsystem FSE
1065.6016.12 6.116 E-16
Example: ":FETC:SPUR? TXB"
Result: 0,890E6,915E6,-87.4,-108.0,ABS,FAILED,
1,893.2E6,893.2E6,-83.2,-108.0,ABS,FAILED,
2,895.7E6,895.7E6,-87.4,-108.0,ABS,FAILED
Features: *RST value: --
SCPI: device-specific
Modes: BTS, MS
TXBand TX-band
OTXBand Not TX-band
RXBand RX-band (option FSE-K11 only)
IDLeband Idle band (option FSE-K10 only)
If no measurement has been performed yet, a query error results.
This command is a query only and therefore has no *RST value assigned. It is available only if
measurement of the spurious emissions is selected (see :CONFigure:SPURious).
:FETCh:SPURious:STEP?
This command reads out the result of the last single step of the measurement of spurious emissions
performed in the STEP mode.
Parameter: The result is output as a list of partial result strings separated by ’,’ as for the
command :FETCh:SPURious[:ALL]?.
Example: ":FETC:SPUR:STEP?"
Result: 0,890E6,915E6,-87.4,-108.0,ABS,FAILED,
1,893.2E6,893.2E6,-83.2,-108.0,ABS,FAILED,
2,895.7E6,895.7E6,-87.4,-108.0,ABS,FAILED
Features: *RST value: --
SCPI: device-specific
Modes: BTS, MS
If no measurement has been performed yet, a query error results.
This command is a query only and therefore has no *RST value assigned. It is available only if
measurement of the spurious emissions is selected (see :CONFigure:SPURious).
To Next Page
Loading...
