HCOPy Subsystem FSE
1065.6016.12 6.120 E-16
:HCOPy:ABORt
This command aborts a running hardcopy output.
Example: ":HCOP:ABOR"
Features: *RST value: -
SCPI: conforming
Modes: A, VA, BTS, MS
This command is an event which is why it is not assigned an *RST value and no query.
:HCOPy:DESTination<1|2> <string>
This command selects the interface and the configuration (1 or 2) for the hardcopy device. The
availability of the parameters depends on the selected data format (see command
:HCOPy:DEVice:LANGuage). { XE "Softkey:SETTINGS DEVICE 1/2" }{ XE "Softkey:HARDCOPY
DEVICE" }
Parameter:
FSE with NT controller <string>::= ‘SYST:COMM:GPIB’ |
’SYST:COMM:SER1’ |
’SYST:COMM:SER2’ |
’SYST:COMM:CENT’ |
’MMEM’
FSE without controller / with DOS controller
Parameter: <string>::= ’MMEM’ |
’SYST:COMM:PRIN’ |
’SYST:COMM:CLIP’
Example: ":HCOP:DEST2 ’MMEM’"
Features: *RST value: -
SCPI: conforming
Modes: A, VA, BTS, MS
This command is an event which is why it is not assigned an *RST value and no query.
:HCOPy:DESTination ’MMEM’ creates a file for the hardcopy output. Command MMEM:NAME
<file_name> defines the file name.
’MMEM’ creates a file for the hardcopy output. Command MMEM:NAME
<file_name> defines the file name. All formats can be selected for
:HCOPy:DEVice:LANGuage.
’SYST:COMM:PRIN’ directs the hardcopy to the printer. The printer is selected with command
SYSTEM:COMMunicate:PRINter:SELect.
GDI should be selected for :HCOPy:DEVice:LANGuage.
’SYST:COMM:CLIP’ directs the hardcopy to the clipboard. EWMF should be selected for
:HCOPy:DEVice:LANGuage.
’SYST:COMM:GPIB’ directs the hardcopy to the IEC/IEEE interface. All formats can be selected
for :HCOPy:DEVice:LANGuage.
’SYST:COMM:SER1’ directs the hardcopy to the serial interface COM1. All formats can be
selected for :HCOPy:DEVice:LANGuage.
’SYST:COMM:CENT’ directs the hardcopy to the parallel IEC/IEEE interface LPT. All formats can
be selected for :HCOPy:DEVice:LANGuage.
This command is an event which is why it is not assigned an *RST value and no query.
To Next Page
Loading...
