FSE SENSe Subsystem
1065.6016.12 6.175 E-16
:[SENSe<1|2>:]CORRection:TRANsducer:DELete
This command deletes the selected transducer factor.
Example: ":CORR:TRAN:DEL"
Features: *RST value: -
SCPI: device-specific
Mode: A
This command is an event and therefore has no *RST value.
Prior to this command, the command SENS:CORR:TRAN:SEL must be sent.
:[SENSe<1|2>:]CORRection:TSET:CATalog?
This command polls the names of all transducer factors stored on the harddisk.
Syntax of output format:
<Sum of file lengths of all subsequent files>,<free memory on hard disk>,
<1st file name>,,<1st file length>,<2nd file name>,,<2nd file length>,....,<nth file name>,
<nth file length>
Example: ":CORR:TSET:CAT?"
Mode: A
Feature: *RST value: -
SCPI: device-specific
:[SENSe<1|2>:]CORRection:TSET:ACTive?
This command reveals the active transducer set. If no transducer set is switched on, a void string will
be output.
Example: ":CORR:TSET:ACT?"
Feature: *RST value: -
SCPI: device-specific
Mode: A
:[SENSe<1|2>:]CORRection:TSET:SELect <name>
This command selected the transducer set designated by <name>. If <name> does not exist yet, a
new set is created.
Parameter: <name>::= name of the transducer set in string data form with a maximum
of 8 characters.
Example: ":CORR:TSET:SEL ’SET1’"
Features: *RST value: -
SCPI: device-specific
Mode: A
This command must be sent prior to the subsequent commands for changing/activating the
transducer sets.
To Next Page
Loading...
