Rohde & Schwarz FSEA20 - Page 257

SENSe Subsystem FSE
1065.6016.12 6.200 E-16
:[SENSe<1|2>:]MIXer:LOSS:TABLe <file_name>
This command sets a conversion loss table.
Parameter: <file_name> := DOS file name
Example: ":MIX:LOSS:table ’mix_1’"
Features: *RST value: no table set
SCPI: device-specific
Mode: A
The command is available only if the external mixer (option FSE-B21) is switched on.
:[SENSe<1|2>:]MIXer:BIAS <numeric_value>
This command sets the bias current.
Example: ":MIX:BIAS 7mA"
Features: *RST value: 0 A
SCPI: conforming
Mode: A
The command is available only if the external mixer (option FSE-B21) is switched on.