Rohde & Schwarz FSEA20 - Page 256

FSE SENSe Subsystem
1065.6016.12 6.199 E-16
:[SENSe<1|2>:]MIXer:HARMonic:TYPE ODD | EVEN | EODD
With BAND LOCK ON, this command sets the type of harmonic.
Example: ":MIX:HARM:TYPE EODD"
Features: *RST value: EVEN
SCPI: device-specific
Mode: A
The command is available only if the external mixer (option FSE-B21) is switched on.
:[SENSe<1|2>:]MIXer:HARMonic:BAND A|Q|U|V|E|W|F|D|G|Y|J
With BAND LOCK ON, this command sets the active band.
Example: ":MIX:HARM:BAND E"
Features: *RST value: U
SCPI: device-specific
Mode: A
The command is available only if the external mixer (option FSE-B21) is switched on.
:[SENSe<1|2>:]MIXer:LOSS[:LOW] <numeric_value>
This command sets the conversion loss of the mixer.
Example: ":MIX:LOSS -12DB"
Features: *RST value: 0 dB
SCPI: conforming
Mode: A
The command is available only if the external mixer (option FSE-B21) is switched on.
:[SENSe<1|2>:]MIXer:LOSS:HIGH <numeric_value>
With BAND LOCK ON, this command sets the conversion loss of the mixer for higher harmonics in
bands with two harmonics (band A: even harmonics, band Q: odd harmonics).
Example: ":MIX:LOSS:HIGH -14DB"
Features: *RST value: 0 dB
SCPI: device-specific
Mode: A
The command is available only if the external mixer (option FSE-B21) is switched on.