SENSe Subsystem FSE
1065.6016.12 6.204 E-16
:[SENSe<1|2>:]POWer:ACHannel:ACPairs 1 | 2 | 3
This command sets the number of adjacent channels (upper and lower channel in pairs).
Example: ":POW:ACH:ACP 3"
Features: *RST value: 1
SCPI: device-specific
Mode: A-F
:[SENSe<1|2>:]POWer:ACHannel:BANDwidth|BWIDth[:CHANnel] 0 Hz to 1000 MHz
This command sets the channel bandwidth of the radio communication system.
Example: ":POW:ACH:BWID 30kHz"
Features: *RST value: 24 kHz
SCPI: device-specific
Mode: A-F
If the channel bandwidth of the adjacent channel is changed the bandwiths of all alternate adjacent
channels are automatically set to the same value.
:[SENSe<1|2>:]POWer:ACHannel:BANDwidth|BWIDth:ACHannel 0 Hz to 1000 MHz
This command defines the channel bandwidth of the adjacent channel of the radio transmission
system.
Example: ":POW:ACH:BWID:ACH 30kHz"
Features: *RST value: 24 kHz
SCPI: device-specific
Mode: A-F
If the channel bandwidth of the adjacent channel is changed the bandwiths of all alternate adjacent
channels are automatically set to the same value.
:[SENSe<1|2>:]POWer:ACHannel:BANDwidth|BWIDth:ALTernate<1|2> 0 Hz to 1000 MHz
This command defines the channel bandwidth of the first/second alternate adjacent channel of the
radio transmission system.
Example: ":POW:ACH:BWID:ALT2 30kHz"
Features: *RST value: 24 kHz
SCPI: device-specific
Mode: A-F
If the channel bandwidth of the alternate adjacent channel no. 1is changed the bandwith of the
alternate adjacent channel no. 2 is automatically set to the same value.
To Next Page
Loading...
