Rohde & Schwarz FSEA20 - Page 344

FSE Command Assignment - Vector Signal Analysis
1065.6016.12 6.287 E-16
SYMBOL
DISPLAY
:DISPlay[:WINDow<1|2>]:TRACe<1...4>:SYMBol DOTS | BARS |OFF
PHASE WRAP
ON/OFF
:CALCulate<1|2>:FORMat PHASe | UPHase
EYE
LENGTH
:DISPlay[:WINDow<1|2>]:TRACe<1...4>:EYE:COUNt <num_value>
ERROR
SIGNAL
:CALCulate<1|2>:FEED ‘XTIM:DDEM:ERR:MPH’
(Querying the results)
:CALCulate<1|2>:MARKer<1|2>:FUNCtion:DDEMod:RESult? MERM| MEPK| MEPS|
PERM| PEPK| PEPS| EVRM| EVPK| EVPS| IQOF| IQIM| ADR| FERR| DEV|
FSRM| FSPK| FSPS| RHO| FEPK
The following commands select the display mode:
MAGNITUDE
:CALCulate<1|2>:FORMat MAGNitude
PHASE
:CALCulate<1|2>:FORMat PHASe
FREQUENCY
:CALCulate<1|2>:FORMat FREQuency
REAL/IMAG
PART
:CALCulate<1|2>:FORMat RIMag
ERROR VECT
MAGNITUDE
:CALCulate<1|2>:FORMat MAGNitude
:CALCulate<1|2>:FEED ‘XTIM:DDEM:ERR:VECT’
POLAR [IQ]
VECTOR
:CALCulate<1|2>:FORMat COMP
:CALCulate<1|2>:FEED ‘XTIM:DDEM:ERR:VECT’
POLAR [IQ]
CONSTELL
:CALCulate<1|2>:FORMat CONS
:CALCulate<1|2>:FEED ‘XTIM:DDEM:ERR:VECT’
SYMBOL
DISPLAY
:DISPlay[:WINDow<1|2>]:TRACe<1...4>:SYMBol DOTS | BARS | OFF
SYMB TABLE
/ ERRORS
:CALCulate<1|2>:FEED ‘XTIM:DDEM:SYMB’
MEMORY
SIZE
:[SENSe<1|2>:]TCAPture:LENGth 1024 | 2048 | 4096 | 8192 | 16384
FRAME
LENGTH
:[SENSe<1|2>:]DDEMod:SEARch:TIME <num_value>
RESULT
LENGTH
:[SENSe<1|2>:]DDEMod:TIME <num_value>
POINTS
PER SYMBOL
:[SENSe<1|2>:]DDEMod:PRATe 1| 2| 4| 8| 16
TRIGGER
see section "SWEEP - TRIGGER"
RANGE
see section "LEVEL - RANGE"
IF
BANDWIDTH
--
IF BW
AUTO
:[SENSe<1|2>:]BANDwidth|BWIDth:RESolution:AUTO ON | OFF
IF BW
MANUAL
:[SENSe<1|2>:]BANDwidth|BWIDth:RESolution <num_value>