Rohde & Schwarz FSW-K40 - Page 79

Remote Control Commands for Phase Noise Measurements
R&S
®
FSW-K40
79User Manual 1173.9286.02 ─ 15
Application <ChannelType>
Parameter
Default Channel Name*)
VSA (R&S FSW-K70) DDEM VSA
WLAN (R&S FSW-K91) WLAN WLAN
*) the default channel name is also listed in the table. If the specified name for a new channel already
exists, the default name, extended by a sequential number, is used for the new channel.
INSTrument:REName <ChannelName1>, <ChannelName2>
This command renames a measurement channel.
Parameters:
<ChannelName1> String containing the name of the channel you want to rename.
<ChannelName2> String containing the new channel name.
Note that you cannot assign an existing channel name to a new
channel; this will cause an error.
Example:
INST:REN 'IQAnalyzer2','IQAnalyzer3'
Renames the channel with the name 'IQAnalyzer2' to 'IQAna-
lyzer3'.
Usage: Setting only
INSTrument[:SELect] <Application>
Selects the measurement application (channel type) for the current channel.
See also INSTrument:CREate[:NEW] on page 76.
For a list of available channel types see Table 8-2.
Parameters:
<Application> PNOise
Phase noise measurements, R&S FSW–K40
SYSTem:PRESet:CHANnel[:EXEC]
This command restores the default instrument settings in the current channel.
Use INST:SEL to select the channel.
Example:
INST:SEL 'Spectrum2'
Selects the channel for "Spectrum2".
SYST:PRES:CHAN:EXEC
Restores the factory default settings to the "Spectrum2" channel.
Usage: Event
Manual operation: See " Preset Channel " on page 37
Controlling the Phase Noise Measurement Channel