Remote Control Commands for Phase Noise Measurements
R&S
®
FSW-K40
89User Manual 1173.9286.02 ─ 15
Usage: Event
LAYout:REPLace[:WINDow] <WindowName>,<WindowType>
This command replaces the window type (for example from "Diagram" to "Result Sum-
mary") of an already existing window in the active measurement channel while keeping
its position, index and window name.
To add a new window, use the LAYout:ADD[:WINDow]? command.
Parameters:
<WindowName> String containing the name of the existing window.
By default, the name of a window is the same as its index. To
determine the name and index of all active windows in the active
measurement channel, use the LAYout:CATalog[:WINDow]?
query.
<WindowType> Type of result display you want to use in the existing window.
See LAYout:ADD[:WINDow]? on page 87 for a list of available
window types.
Example:
LAY:REPL:WIND '1',MTAB
Replaces the result display in window 1 with a marker table.
LAYout:SPLitter <Index1>,<Index2>,<Position>
This command changes the position of a splitter and thus controls the size of the win-
dows on each side of the splitter.
Compared to the DISPlay[:WINDow<n>]:SIZE on page 86 command, the
LAYout:SPLitter changes the size of all windows to either side of the splitter per-
manently, it does not just maximize a single window temporarily.
Note that windows must have a certain minimum size. If the position you define con-
flicts with the minimum size of any of the affected windows, the command will not work,
but does not return an error.
Configuring the Result Display
To Next Page
Loading...
