Rohde HMT 600 - Adjusting the Angle on the Foot Pedal; Installation; Installing the Wiring on the Machine

43 / 207 - EN -
7.5. Adjusting the angle on the foot pedal
The pedal angle of the foot pedal is set to the "steep" setting as standard on delivery. The pedal can be adjusted to a
"flat" setting.
Description
Changing settings:
1) Loosen the mounting angle on the underside of the pedal with a Phillips
screwdriver.
2) Bring the pedal body into the required position.
3) Pay attention to the position of the lug on the short side of the pedal.
4) Reattach the mounting angle on the underside of the pedal with a Phillips
screwdriver (torque = 4 Nm).
5) Pay attention to the position of the mounting angle on the pedal body.
8. Installation
8.1. Installing the wiring on the machine
8.1.1. Installing the power cable on the machine
DANGER
Danger high voltage!
Before working on the machine, pull the power plug out of the socket.
Lug in upper
detent
Mounting angle attached to
the outside of pedal body
Lug in lower detent
Mounting angle attached to
the bottom of pedal body
Pedal underside
Mounting angle with
screw
(Tool: Phillips
screwdriver)
Flat setting
Steep setting
Pedal body is
supported in a high
position