Roland GO:KEYS 5 Reference Manual

56
Editing the system settings
00 00 ThruThru
L in L out
R outR in
01 01 EqualizerEqualizer
This is a four-band stereo equalizer (low, mid x 2, high).
L in L out
R outR in
4-Band EQ
4-Band EQ
Parameter Value Explanation
High Gain -15–+15 [dB]
Amount of boost/cut for the high-
frequency range
Low Gain -15–+15 [dB]
Amount of boost/cut for the low-
frequency range
02 02 Mid-Side EQMid-Side EQ
This eect allows the left/right signals that have similar phase to be
tonally adjusted in a dierent way than the left/right signals that have
dierent phase.
L in L out
R outR in
Mid
Side
Parameter Value Explanation
S High Gain -12.00–+12.00 [dB]
Amount of boost/cut for the high-
frequency range
M High Gain -12.00–+12.00 [dB]
Amount of boost/cut for the high-
frequency range
03 03 SpectrumSpectrum
This is a stereo spectrum. Spectrum is a type of lter which modies
the timbre by boosting or cutting the level at specic frequencies.
L in L out
R outR in
Spectrum
Spectrum
Parameter Value Explanation
Band8
(8000Hz)
-15–+15 [dB] Gain of each frequency band
Band1
(250Hz)
04 04 IsolatorIsolator
This is an equalizer which cuts the volume greatly, allowing you to add
a special eect to the sound by cutting the volume in varying ranges.
L in L out
R outR in
Isolator Low Boost
Isolator Low Boost
MEMO
This eect can be used for both TOTAL FX and MFX. The parameters
than you can set when using the eect with the MFX are limited to
those marked with a (*1).
Parameter Value Explanation
High Level
(*1) -60–+4 [dB]
These boost and cut each of the High,
Middle, and Low frequency ranges.
At -60 dB, the sound becomes inaudible.
0 dB is equivalent to the input level of
the sound.
Low Level
(*1) -60–+4 [dB]
Mid Level -60–+4 [dB]
Anti Phase Low OFF, ON
Turns the Anti-Phase function on and off
for the Low frequency ranges.
When turned on, the counter-channel of
stereo sound is inverted and added to
the signal.
Anti Phase Low
Level
0–127
Adjusts the level settings for the Low
frequency ranges.
Adjusting this level for certain
frequencies allows you to lend emphasis
to specific parts (This is effective only for
stereo source.).
Anti Phase Mid OFF, ON Settings of the Anti-Phase function for
the Middle frequency ranges.
The parameters are the same as for the
Low frequency ranges.
Anti Phase Mid
Level
0–127
Low Boost OFF, ON
Turns Low Booster on/off.
This emphasizes the bottom to create a
heavy bass sound.
Low Boost Level 0–127
Increasing this value gives you a heavier
low end.
Depending on the Isolator and filter
settings this effect may be hard to
distinguish.
Level 0–127 Output Level
05 05 Low BoostLow Boost
Boosts the volume of the lower range, creating powerful lows.
L in L out
R outR in
Low Boost 2-Band EQ
Low Boost 2-Band EQ
Parameter Value Explanation
Boost Frequency
50, 56, 63, 71, 80,
90, 100, 112, 125
[Hz]
Center frequency at which the lower
range will be boosted
Boost Gain 0–+12 [dB]
Gain of the lower range that will be
boosted

Roland GO:KEYS 5 Specifications

General

Brand	Roland
Model	GO:KEYS 5
Category	Electronic Keyboard
Language	English