Roland GO:KEYS 5 Reference Manual

66
Editing the system settings
49 49 LimiterLimiter
Compresses signals that exceed a specied volume level, preventing
distortion from occurring.
L in L out
R outR in
Limiter 2-Band EQ
Limiter 2-Band EQ
Parameter Value Explanation
Release 0–127
Adjusts the time after the signal volume
falls below the Threshold Level until
compression is no longer applied.
Threshold 0–127
Adjusts the volume at which
compression begins
50 50 SustainerSustainer
By compressing loud input and boosting low input, this eect keeps
the volume consistent to produce a sustain eect without distortion.
L in L out
R outR in
Sustainer 2-Band EQ
Sustainer 2-Band EQ
Parameter Value Explanation
Attack 0–127 Time until the volume is compressed
Sustain 0–127
Adjusts the range in which a low input
signal is boosted to a consistent volume.
Higher values produce longer sustain.
51 51 TransientTransient
This eect lets you control the way in which the sound attacks and
decays.
L outL in
R in
R out
Envelope
Controller
Envelope
Controller
Parameter Value Explanation
Attack -50–+50
Character of the attack.
Higher values make the attack more
aggressive; lower values make the attack
milder.
Release -50–+50
Character of the decay.
Higher values make the sound linger;
lower values make the sound cut off
quickly.
52 52 GateGate
Cuts the reverb’s decay according to the volume of the sound sent
into the eect. Use this when you want to create an articial-sounding
decrease in the reverb’s decay.
L in L out
R outR in
Gate
Gate
Parameter Value Explanation
Threshold 0–127
Volume level at which the gate begins
to close
Balance
D100: 0W–D0:
100W
Volume balance between the direct
sound
(D) and the effect sound (W)
53 53 DelayDelay
This is a stereo delay.
When Feedback Mode is NORMAL:
R out
L out
Balance W
Balance W
Balance D
Balance D
L in
R in
Feedback
Feedback
2-Band EQ
2-Band EQ
Delay
Delay
When Feedback Mode is CROSS:
R out
L out
Balance W
Balance W
Balance D
Balance D
L in
R in
Feedback
Feedback
2-Band EQ
2-Band EQ
Delay
Delay
MEMO
This eect can be used for both TOTAL FX and MFX. The parameters
than you can set when using the eect with the MFX are limited to
those marked with a (*1).
Parameter Value Explanation
Feedback
(*1) -98–+98 [%]
Adjusts the proportion of the delay
sound that is fed back into the effect.
Negative (-) settings will invert the
phase.
Balance
(*1)
D100: 0W–D0:
100W
Volume balance between the direct
sound (D) and the delay sound (W)
Sync Left OFF, ON
If this is ON, the rate synchronizes with
the tempo of the rhythm.
Ø “Changing the tempo (TEMPO)” (p. 36)

Roland GO:KEYS 5 Specifications

General

Brand	Roland
Model	GO:KEYS 5
Category	Electronic Keyboard
Language	English