Roland SP-404MK - Inputting Sound; Inputting from Instruments;Mic;Guitar

InputtingSoundfromanElectronicMusicalInstrument,MicorGuitar
Youcanconnectyourelectronicmusicalinstrument,micorguitartotheSP-404MKⅡforaudioinput.
ConnectanelectronicmusicalinstrumenttotheLINEINjack(s)ontherearpanel.Whenusingamicor
guitar,plugthemintotheINPUTjackonthefrontpanel.
Youcanconnecthigh-impedancedeviceslikeguitarsandbassguitarstotheINPUTjackonthefront
panel.Whenconnectingaguitarorbassguitar,setthe[MIC/GUITAR]switchonthefrontpaneltothe
right-handside.
1
Pressthe[EXTSOURCE]button.
The[EXTSOURCE]buttonlightsup.Thisinputstheaudiooftheconnecteddevice.
The[EXTSOURCE]buttonblinksrediftheleveloftheinputsignalistoohigh.Inthiscase,theinput
audiomaysounddistorted.
2
Holddownthe[SHIFT]buttonandpressthe[EXTSOURCE]button.
Theinputsettingscreenappears.
3
Turnthe[CTRL3]knobtoadjustthevolumeoftheaudioinput.
Whenyouraisethevolume,theaudioisoutputfromtheconnecteddevice.
4
Whenyoufinishmakingthesettings,pressthe[EXIT]button.
5
Tostoptheaudioinputfromtheconnecteddevice,pressthe[EXTSOURCE]button.
The[EXTSOURCE]buttongoesdark.Thisstopstheaudiofromtheconnecteddevice.
6