Roland SP-404MK - Adding Effects to a Sample (BUS FX)

UsingtheEffects
AddingEffectstoaSample(BUSFX)
YoucanusethevariouseffectsbuiltintotheSP-404MKⅡtoprocesstheplaybackaudioinuniqueways.
Youcanassigntheeffectsyouliketotheeffectbuttons.
Fordetails,referto“AssigningtheDesiredEffecttoanEffectButton(DIRECTFX).”
Presstheeffectbuttons.
Pressthebuttonsoftheeffectsyouwanttoapply,includingthe[FILTER+DRIVE]button,the
[RESONATOR]button,the[DELAY]button,the[ISOLATOR]button,the[DJFXLOOPER]button,andthe
[MFX]button.
Thisturnstheeffectson.
1
Presspads[1]‒[16]toplaybackthesamples.
Effectsareappliedtothesamples.
2
Usethe[CTRL1]‒[CTRL3]knobstoadjusttheparameters.
Theparameterschangehowtheeffectsareapplied.
Youcanalsoaccesstheeffectsub-parametersbyholdingdownthe[VALUE]knobandoperatingthe
knobs.
3