Roland SP-404MK - Assigning Effects to BUS 1 and BUS 2

UsingtheEffects > AddingEffectstoaSample(BUSFX)
AssigningEffectstoBUS1andBUS2
Hereʼshowtoassignthebuilt-ineffectsofthisunittoBUS1orBUS2.Youcanusetwotypesofeffectsseparately.
Youcanassignthebuilt-ineffectsofthisunittoBUS3orBUS4.Uptofoureffectsareavailable.
ToassignaneffecttoBUS3orBUS4,changethesettingsintheeffectsettingscreen.
→“ConfiguringtheEffectSettings(EFXSET)”
Pressthe[BUSFX]buttontoselectthebustoconfigure.
Whenthebuttonislitorange,BUS1isselected;andwhenthebuttonisblinkingorange,BUS2is
selected.
1
Pressthe[FILTER+DRIVE]‒[MFX]buttonstoselecttheeffecttoassigntothebus.
2