Condions for Seable Objects to Be Printed On
The condions for objects to be printed on that can be set in the machine are shown below.
Maximum size Width 538 mm (21.2 in.)
Length 360 mm (14.2 in.)
Thickness Height 100 mm
Maximum weight 5 kg (11.0 lb.)
IMPORTANT
• Do not use objects to print on that are charged with stac electricity.
• This printer cannot print on all materials. When selecng the object to be printed on, be sure to carry out tesng in advance to
make sure that sasfactory print quality can be obtained.
• There is a limit to the variaon in the unevenness on the print surface.
P. 64「Notes When the Print Surface Is Uneven」
• Depending on the type of object to print on and the installaon method, the height may not be set correctly. The machine may
malfuncon if prinng is performed when an incorrect installaon method is used or if prinng is performed on an inappropriate
material. Do not use objects to print on that match the status or material shown below.
Objects that easily become
loose
If the object to be printed on is not rmly
held in place, the head gap sensor cannot
detect the height correctly. Be sure to se-
cure the object to be printed on rmly in
place. If the media becomes loose, you can
use a substance such as commercially avail-
able adhesive tape to hold the media in
place.
Objects made from so
material
If the object to be printed on is made from
so material, the pressure it applies on the
head gap sensor is too weak. This prevents
its height from being detected correctly.
Object to Be Printed On
14 1. Basic Information
To Next Page
Loading...
Need help?
General