These are the main messages that appear on the machine's display to prompt correct operaon. They do not indi-
cate any error. Follow the prompts and take acon accordingly.
1 ■ 2 ■ 3 ■ 4 ■ 5■ 6 ■ 7 ■ 8 ■
Only a small amount of ink remains.
Replace the ink cartridge indicated by the ashing number with a new cartridge.
PRESS THE POWER KEY TO CLEAN
This message appears when the machine has not been used for approximately a month.
Turn on the sub power once a month.
CIRCULATING INK
White ink is being circulated inside the machine. This acon is automacally performed to clear the white ink
precipitaon.
Wait unl the displayed message changes.
SHAKE WHITE INK CARTRIDGE
This message appears when an acon is selected under "ACTION" (including "CIRCULATE") in the start mer
sengs.
Remove the white ink cartridge, shake it 50 mes (about 20 seconds) with a stroke length of around 5 cm (2 in.)
from each end, and then reinsert it. Aerwards, press [ENTER] to switch o the sub power.
RELATED LINKS
・ P. 123 "Maintenance of Ink Cartridges"
・ P. 92 "Seng the Start Timer"
FINISHED PRINT
Prinng is nished.
Press [ENTER].
SET/REMOVE CARTRIDGE
This message appears at mes such as during ink cartridge replacement.
Insert or remove the ink cartridge indicated by the ashing number.
CLOSE XXX COVER DRY-UP MAY DAMAGE THE HEAD
The front cover or panel cover is open.
Close the front cover or panel cover or both. If the message is le displayed, the print heads may get dry, resulng
in malfuncon.
CLOSE XXX COVER
The front cover or panel cover is open when seng the start mer.
Close the front cover or panel cover or both. If the message is le displayed, seng the mer will not be complet-
ed.
RELATED LINKS
・ P. 92 "Seng the Start Timer"
Messages
190 3. Messages on the Operation Panel
To Next Page
Loading...
Need help?
General