Roland VersaUV LEF2-200 User Manual

This secon describes the error messages that may appear on the machine's display, and how to take acon to
remedy the problem. If the acon described here does not correct the problem or if an error message not descri-
bed here appears, contact your authorized Roland DG Corporaon dealer.
AREA TOO SMALL CONTINUE?
The size of the data is larger than the print area of the loaded object to be printed on.
To connue prinng without correcng this, press [ENTER]. The poron extending beyond the print area will not
be printed. To stop prinng, stop sending data from the computer and hold down [SETUP] for one second or lon-
ger. Make the print area wider by replacing the object to be printed on with a larger object or by changing the
posion of the object, then send the data again.
PRINT AREA TOO SMALL
The size of the test print is larger than the print area of the loaded object to be printed on.
Press any key on the operaon panel to go back to the main menu. Make the print area wider by replacing the
object to be printed on with a larger object or by changing the posion of the object, then redo the test prinng.
CANCELED FOR TABLE HEIGHT
The object to be printed on was detected in a posion (at a height) at which it hits the print heads.
Press any key (except the sub power switch) on the operaon panel, and the message disappears. If the setup of
the object to be printed on is completed, the setup is canceled. Redo the setup.
RELATED LINKS
・ P. 44 "Step 2: Start Prinng"
・ P. 59 "Adjusng the Height"
CHECK TABLE HEIGHT
The object to be printed on was detected in a posion (at a height) at which it hits the print heads.
Remove the object to be printed on (remove the cause of the failure) or change its posion. Aer verifying the
message, press [ENTER].
RELATED LINKS
・ P. 44 "Step 2: Start Prinng"
・ P. 59 "Adjusng the Height"
CHECK HEIGHT OF HEAD REFRESHER
The possibility of the print heads colliding into the head refresher (or other obstacle) when they move for head
refreshing is detected.
Press [ENTER] to clear the message.
The jig may be in the way or it may not have been aached correctly. Correctly reaach the head refresher by
removing the jig or reviewing how the jig is aached. Then, perform head refreshing again.
RELATED LINKS
・ P. 133 "Head Refreshing Method"
Error Messages
3. Messages on the Operation Panel 193

Roland VersaUV LEF2-200 Specifications

General

Brand	Roland
Model	VersaUV LEF2-200
Category	Printer
Language	English