Page | 14
INSERTING THE CABLE BETWEEN THE DISTRIBUTION BOX AND
TECHNICAL SYSTEM
(1) Distribution box
(2) Connecting piece with internal cable gland
(3) Tube clamp
(4) Flexible tube with cable (technical system direction)
(5) Flexible tube with cable (drive direction)
Caution! The connecting cable (4) (5) must correspond to the cable characteristics
specified in Rollo Solar supply cable table! We recommend using the original extension
cable, article no. 6100-0023.
Installation steps
1. Remove the internal cable gland (2)
2. Slide the tube clamp (3) over the flexible tube (4)
3. Insert the cable through the flexible tube (4) and connecting piece (2)
into the distribution box (1)
4. Tighten the tube clamp (3) with a VA Phillips screwdriver
To Next Page
Loading...