Page | 26
CONNECTING THE CONTROLLER WITH THE CABLE
Caution! Electrical connection work may only be carried out by a qualified, skilled
electrician!
Caution! Switch off the power supply to the control board during all electrical work!
The following images show a completely wired RSC 3 circuit board and
a RSC 4 with connected PS1 switch.
Please note: The programming of the circuit board is retained following a power failure
as this is saved in an EPROM.
Caution! A maximum of 24 VOLT DC, 500 mA can be connected to the ‘POS AUF’ and ‘POS
ZU’ position reports. Exceeding these values will result in irreparable damage to the
electronic components.
To Next Page
Loading...