Page | 57
11. Has the error been corrected?
If yes, check that the system works by running ‘AUF’ (OPEN) and ‘ZU’
(CLOSED) at a minimum
If not, please contact Rollo Solar
CONTROLLER NOT PROGRAMMED
Error:
The controller is not programmed
Troubleshooting:
Program the controller
EMERGENCY MODE ACTIVE
Error:
Emergency mode is active / Caution! Configured end positions are ignored
Troubleshooting:
Deactivate emergency mode; see the section ‘Emergency mode’
THERMOPROTECTOR ACTIVE
Error:
The thermosensor is active; the system cannot be operated
Troubleshooting:
The error message for the thermoprotector input is automatically reset as soon as the
thermoprotector switch is inactive again (the drive has cooled down).
To Next Page
Loading...