Page | 37
Configuring the ‘ZU’ end position – cover closed
1. Starting programming: Press and hold the ‘PROG’ and ‘ZU’ (CLOSED) operating
buttons until the two LEDs ‘PROG’ and ‘ZU’ (CLOSED) are illuminated.
2. ZU – configuring the end position: Use the ‘AUF’ (OPEN) and ‘ZU’ (CLOSED)
operating buttons to move the system to the desired end position; the pool should
be covered completely.
3. Finishing programming: Press and hold the ‘PROG’ and ‘ZU’ (CLOSED) operating
buttons until ‘PROG’ LED is no longer illuminated.
Configuring the ‘AUF’ end position – cover open
1. Starting programming: Press and hold the ‘PROG’ and ‘AUF’ (OPEN) operating
buttons until the two LEDs ‘PROG’ and ‘AUF’ (OPEN) are illuminated.
2. OPEN – configuring the end position: Use the ‘AUF’ (OPEN) and ‘ZU’ (CLOSED)
operating buttons to move the system to the desired end position; the pool should
be completely open. Make sure that the first profile is flush with the enclosure.
3. Finishing programming: Press and hold the ‘PROG’ and ‘AUF’ (OPEN) operating
buttons until the ‘PROG’ LED is no longer illuminated.
To Next Page
