Page | 50
Step 1: Resetting the receiver:
In order to ensure that any existing programming is erased, please perform a ‘RESET’.
Do so by pressing and holding any channel button on the receiver module for approx.
10 sec. until all channel LEDs are blinking; then release the channel button. All channels
are deleted (memory is empty).
Step 2: Teaching in handheld transmitter buttons
In order to teach in a handheld transmitter button on an output channel, you need to
press the corresponding channel button on the receiver briefly (the channel LED blinks).
Then press the desired handheld transmitter button and hold it until the channel LED
lights up continually for approx. one second.
Carry out this same procedure accordingly for all channel buttons (Auf (Open), Zu
(Closed), Stop and optional Licht (Light). Additional transmitters (maximum of 256) can
then be taught in within a period of 10 seconds. If no input is provided within this
period, the respective LED goes out and the programming process is concluded.
Please note! Erasing individual handheld transmitter buttons
In order to erase a handheld transmitter button on an output channel, you need to
press the corresponding channel button on the receiver briefly (the channel LED blinks).
Then press the desired handheld transmitter button (channel LED blinks more rapidly)
and hold it for approx. five seconds until the channel LED lights up continually for
approx. one second. The teaching in or erasing process can be terminated by pressing
the channel button again (channel LED goes out).
To Next Page
Loading...
