Model 3095FB Multivariable Transmitter with Modbus Protocol
Modbus Protocol Guide
Page 48 of 79
6.3 Restore Factory Trim Defaults
Triggering the following coils will cause the 3095FB to revert to the Factory Trim Defaults.
The 3095FB must then be recalibrated.
Table 6-4 Reset Factory Trim Defaults
Modbus Access
DESCRIPTION
Address
Address
Type
Attributes
Functional
Area
Data / Control
0031 Coil R/W, WP Reset Trim
to Factory
Defaults
DP
0032 Coil R/W, WP SP
0033 Coil R/W, WP PT
*Attributes: R/W = Read/Write, RO = Read Only, WP = Write Protected
**These registers are available at multiple Modbus addresses (see Section 2.3 located in
the Modbus Protocol Guide)
To Next Page
Loading...
