00809-0100-4835 Rev BD
July 2016
5-2
Electrical shock can result in death or serious injury.
• Avoid contact with the leads and terminals when the circuit is
Process leaks could result in death or serious injury.
• Install and tighten all four flange bolts before applying
pressure.
• Do not attempt to loosen or remove flange bolts while the
transmitter is in service.
Maintenance of traceability of any replacement parts is the
responsibility of the user (see Important Notice at the beginning of this
manual preceding Section 1).
Residual process fluid may remain after disassembly of process
flanges. If this fluid is potentially contaminated, take appropriate safety
measures.
Replacement equipment or spare parts not approved by Rosemount
Nuclear Instruments, Inc. for use could reduce the pressure retaining
capabilities of the transmitter and may render the instrument
dangerous or adversely impact its qualified status.
• Use only components supplied with the 3152, 3153 or 3154
transmitter or designated by Rosemount Nuclear Instruments,
Inc. as spare parts for the 3152, 3153 or 3154.
To Next Page
Loading...
