00809-0100-4835 Rev BD
6-2
Process leaks could result in death or serious injury.
• Install and tighten all four flange bolts before applying
pressure.
• Do not attempt to loosen or remove flange bolts while the
transmitter is in service.
Maintenance of traceability for any replacement part is the
responsibility of the user (see Important Notice at the beginning of
this manual preceding Section 1).
In the event a spare part kit is needed for on-site transmitter
maintenance that is not represented within the transmitter spare parts
list, please contact Rosemount Nuclear Instruments, Inc.
Residual process fluid may remain after disassembly of process
flanges. If this fluid is potentially contaminated, take appropriate
safety measures.
Replacement equipment or spare parts not approved by Rosemount
Nuclear Instruments, Inc. for use could reduce the pressure retaining
capabilities of the transmitter and may render the instrument
dangerous or adversely impact its qualified status.
• Use only components supplied with the 3152, 3153 or 3154
transmitter or designated by Rosemount Nuclear Instruments,
Inc. as spare parts for the 3152, 3153 or 3154.
To Next Page
Loading...
