00809-0100-
5-3
The Rosemount 3150 Series transmitters have no moving parts and
require a minimum of scheduled maintenance. Calibration procedures
for range adjustments are outlined in Section 3 Calibration. A
calibration check should be conducted after inadvertent exposure to
overpressure, unless your plant considers this factor separately in the
plant error analysis.
Test terminals are available for in-process checks. For further checks,
the transmitter can be divided into two active physical components: the
sensor module and the electronics assembly.
An exploded view drawing of the transmitter is provided in Figure 5-1.
In the following procedures, numbers in parentheses refer to item
numbers in the exploded view.
To Next Page
Loading...
