00809-0100-4835 Rev BD
SECTION 1: INTRODUCTION
Figure 1-1 – Standard Transmitter
Nameplate
This manual is designed to assist in installing, operating and
maintaining the Rosemount 3150 Series Pressure Transmitters.
Instructions for the 3152, 3153 and 3154 models are included in this
manual. Where differences in instructions between the models occur
they shall be noted within those instructions. The manual is organized
into the following sections:
Section 2: Installation
Provides general, mechanical, and electrical installation
considerations.
Section 3: Calibration
Provides transmitter calibration procedures.
Section 4: Operation
Provides a description of how the transmitter operates.
Section 5: Maintenance and Troubleshooting
Provides basic hardware troubleshooting considerations including
disassembly and reassembly procedures and post assembly tests.
Section 6: Transmitter Spare Parts
Provides order information for transmitter spare parts.
Refer to the applicable Rosemount Qualification/Test Reports, Product
Data Sheets and/or Specification Drawings for details on testing,
performance specifications and dimensional drawings for each model.
Figure 1-1 shows the standard transmitter nameplate and where
transmitter information is stamped onto the nameplate. Nameplate
material is stainless steel.
Unique Transmitter Serial Number
is stamped here
Transmitter Model Number is
stamped here
Factory Calibrated Span
is stamped here
Transmitter Maximum Power
Supply Limit is stamped here
Maximum Working
Pressure is stamped here
To Next Page
Loading...
