Ross Ultritouch - Glossary

Ultritouch+Ultrix User Guide (v1.0) Glossary • 45
Glossary
The following terms are used throughout this guide:
Breakaway — an act of performing a switch on only some of the signals grouped together under one label.
Connection Point — setting to define a communication connection between Ultritouch and a device in the routing
system.
Crosspoint — a switch within a matrix. For example, the connection of signal IN 1 to OUT 1 requires one
crosspoint.
Destination — a signal output from the routing system.
Hard Panel — the physical Ultritouch panel that provides a touchscreen interface to the menu system.
IP Address — a setting that defines the Internet protocol address of a device within a network.
Label — text that is used by control displays to identify a signal as an input or output.
Level — refers to a section of a routing system. For example, a video router would be one level and an audio router
would be a second level.
Logical (virtual) Label — a name for a group of routing system inputs or outputs.
Logical (virtual) Routing — the action of switching a group of otherwise unrelated signals via a common label
(name).
Remote Control Panel (RCP) — a physical hardware panel of buttons that is used to control the routing system.
Salvo — a system wide sequence of matrix control operations and crosspoint actions.
Soft Panel — a DashBoard software interface that represents a panel of buttons that is used to control the routing
system.
Source — a signal input to the routing system.
Virtual Label — a name for a group of routing system inputs or outputs.
Virtual Routing — the action of switching a group of otherwise unrelated signals via a common label (name).