Employee Setup
AC-115 Software Installation and User’s Guide Page 57
Add Employees — Rights Settings
Figure 64: Employee Permissions
In the Rights tab, you can specify which doors the employee
has access to.
This is done by selecting which Event Actions (Lock “Strike” and
“Auxiliary” Output activation) occur when the user enters a
valid code at each of the doors.
In the example window on top, there are four doors installed in
the system.
For doors 1 and 4, both the Lock “Strike” and the “Auxiliary” are
activated upon entry of a Valid Code.
When a valid code is entered at door 2 but the employee
does not have access to it, Events “Door Opened” and
“Auxiliary Opened” do not occur and Event Action “Door Not
Opened” occurs; therefore, this user has no access to door 2.
For door 3 only, the Lock “Strike” Output activation Event
Action occurs when a valid code is entered.
When you have finished entering all the settings for this
employee, click OK at the bottom of the window. The new
employee information must be downloaded to the AC-115
network before the employee’s settings are fully enabled.
To Next Page
Loading...
Need help?
General
