Rosslare AYC-E60B - Setting the Backlight Behavior; Setting the Credential Format

Reader Operation
32 AYC-E/Q60 Series Installation and Programming Manual
4.2.8 Setting the Backlight Behavior
To set the backlight behavior:
1. Enter Programming mode.
2. Press 6 to enter Menu 6.
The left LED turns red.
3. Enter one of the following codes:
 10 – Always off
 11 – Always on
 12 – Backlight is off, activates for 10 seconds when a key is
pressed (left LED also goes on), after which it dims until off
(left LED also goes off)
 13 – Backlight is dimmed, activates for 10 seconds when a
key is pressed (left
LED also goes on), after which it returns to
a dimmed level
You hear three beeps.
The system returns to Standby mode.
4.2.9 Setting the Credential Format
To set the credential format:
1. Enter Programming mode.
2. Press 6 to enter Menu 6.
The left LED turns red.
3. Enter one of the following codes:
 61 for Rosslare Proximity
 62 for HID Prox
 63 for Rosslare Proximity and HID Prox (default)
Red
Green
Green
Red
Red
Green
Green