Rosslare AYC-E60B User Manual

Controller Operation
62 AYC-E/Q60 Series Installation and Programming Manual
5.9.16 PIN Code Length/Factory Default Settings
You must be very careful before using this command!
Changing the PIN code length also erases the entire memory
contents, including all user and special codes, and returns all
codes to their factory default settings.
To change the PIN code length:
1. Enter Programming mode.
2. Select the desired PIN code length as follows:
 00 – Returns to factory defaults and sets a 4-digit code
 05 – Returns to factory defaults and sets a 5-digit code
 06 – Returns to factory defaults and sets a 6-digit code
 08 – Returns to factory defaults and sets a 4–8 digit code
When choosing the 4–8 option, please note that you should
either enter zeros before the code, or press # at the end (for
example if your code is 12345, enter either 00012345 or
12345#).
Both LEDs flash red.
3. Enter your 4-digit Programming code.
If the Programming code is valid, all memory is erased. You hear
three beeps and the controller returns to Normal mode.
If the Programming code is invalid, you hear a long beep and the
controller returns to Normal mode without erasing the memory
contents.
Red
Red
Green

Rosslare AYC-E60B Specifications

General

Brand	Rosslare
Model	AYC-E60B
Category	Card Reader
Language	English