Rosslare AYC-E60B - Setting the Backlight Behavior; Selecting the Credential Format

Controller Operation
AYC-E/Q60 Series Installation and Programming Manual 53
5.9.11 Setting the Backlight Behavior
The controller allows you to define the way the units' backlight
works.
To set the backlight behavior:
1. Enter Programming mode.
2. Press 6 to enter Menu 6.
The left LED flashes green.
3. Enter one of the following codes:
 5000 – Backlight off
 5100 – Backlight on (default)
 5200 – Backlight is off, activates for 10 seconds when
a key is
pressed, after which it dims until off
 5300 – Backlight is dimmed, activates for 10 seconds when a
key is pressed, after which it returns to a dimmed level
5.9.12 Selecting the Credential Format
To select the credential format:
1. Enter Programming mode.
2. Press 6 to enter Menu 6.
The left LED flashes green.
3. Enter one of the following codes:
 6100 – Rosslare Proximity
 6200 – HID Prox
 6300 – Rosslare Proximity + HID Prox (default)
Green
Green
Green
Green
Green
Green