Table of Contents
AYC-E/Q60 Series Installation and Programming Manual iii
Table of Contents
1. Introduction ................................................................ 9
1.1 Box Content ........................................................................... 9
1.2 Ancillary Equipment .............................................................. 10
2. Technical Specifications ............................................ 11
3. Installation ................................................................ 13
3.1 Mounting the AYC-E60 ......................................................... 13
3.2 Mounting the AYC-Q60 ........................................................ 14
3.3 Wiring .................................................................................. 16
3.3.1 Wiring the Unit as a Reader .......................................................... 16
3.3.2 Wiring the Unit as a Controller ..................................................... 17
4. Reader Operation ...................................................... 20
4.1 Standby Mode ...................................................................... 20
4.2 Programming as a Reader ...................................................... 20
4.2.1 Entering Programming Mode ........................................................ 22
4.2.2 Exiting Programming Mode .......................................................... 22
4.2.3 Selecting Keypad Transmission Format ......................................... 23
4.2.4 Selecting HID Prox Card Transmission Format ............................... 28
4.2.5 Selecting Rosslare Proximity Card Transmission Format ................. 29
4.2.6 Changing the Programming Code ................................................ 31
4.2.7 Changing the Facility Code ........................................................... 31
4.2.8 Setting the Backlight Behavior ...................................................... 32
4.2.9 Setting the Credential Format ....................................................... 32
4.2.10 Return to Factory Default Settings ................................................ 33
4.2.11 Replacing a Lost Programming Code ............................................ 33
To Next Page
Loading...
