Controller Operation
40 AYC-E/Q60 Series Installation and Programming Manual
5.9 Programming as a Controller
Programming is performed solely via the unit's keypad driven
Programming Menu System. To reach the Programming Menu
System, the unit must first be placed into Programming mode. See
Section 5.9.1 for more information.
During the manufacturing process, certain codes and settings are pre-
programmed. These settings are the called the default factory
settings.
Table 4 shows the names of all the controller programming menus. It
also shows of all the default factory codes and settings.
Table 4: Controller Programming Menu
Menu
No.
Menu Description Default
4
digits
5
digits
6 digits 4–8 digits
1 Changing Lock Strike Code 2580 25802
258025 25802580
2 Changing Auxiliary Code 0852 08520
085208 08520852
3 Changing Program Code 1234 12341
123412 12341234
4 Changing Normal/Secure Code 3838 38383
383838 38383838
5 Changing Normal/Bypass Code N/A
6 Changing Door Release Time 0004
Defining auxiliary inputs/outputs 2004
Set Lockout 4000
Backlight Behavior 5100
Credential Format 6300
7 Enrolling PIN Code N/A
8 Deleting PIN Code N/A
9 Code Assignment with
Strike/Auxiliary
N/A
0 Return to Factory
Defaults/Change PIN Code Length
N/A
You will find instructions for each of the above menu items in the
following subsections.
To Next Page
Loading...
Need help?
General
