rotork CML-100 - 10.3 Basic Setup Flowchart

Installation & Maintenance Instructions
28
10. Basic Setup
10.3 Basic Setup Flowchart
STEP 1
SELECT LOCAL
OPERATION
STEP 2
SET OUTPUT
TORQUE/THRUST
STEP 4
SET CLOSE LIMIT
OF TRAVEL
STEP 5
SET OPEN LIMIT
OF TRAVEL
STEP 6
CALIBRATE COMMAND
SIGNAL ZERO SETPOINT
STEP 7
CALIBRATE COMMAND
SIGNAL SPAN SETPOINT
STEP 3
SELECT ACTION AT END
OF TRAVEL ( LIMIT OR FORCE)
STEP 8
SET COMMAND
SIGNAL INVERT
STEP 9
SET TRANSMITTER
SIGNAL INVERT
STEP 10
DEADBAND
A4US
US
A4
US A4
US
A4