Installation & Maintenance Instructions
44
10. Basic Setup
10.13 Completing Basic Setup (cont'd)
Ensure that the spigot face is clean and greased with the
o-ring seal fitted and in good condition.
Note: Actuators fitted with Local Controls or Reserve Power
Pack only.
Reconnect wiring loom between the main PCB and the top
cover before replacing the assembly.
Carefully align the cover assembly and handwheel shaft.
Ensure that all wiring is fitted correctly and will not foul the
top cover assembly once fitted.
Lower the top cover in to place. Check operation of the
handwheel and that no cables are trapped.
Tighten the four cap head screws.
Fig 10.66
Fig 10.67
Fig 10.68
A4US
US
A4
US A4
US
A4
To Next Page
Loading...
Need help?
General
