BC-3500 Bill and Coin Changer
2-10 25238801
5. Turn ON and OFF Maximum Capacity (MC) payout by pressing either the up (
) or down (
) button. No
other buttons are needed to change the MC mode. The Maximum Capacity mode of operation has three big
advantages and one requirement. The requirement is that all three coin hoppers must be loaded with the
same value coin or token. The advantages are:
A. The time required to vend and replenish is typically only 1/3 of that required in the NON-MC mode.
B. All three hoppers will be emptied equally and the machine will not “go empty” until all three have been
found to have no coins available.
C. In the event of a hopper failure (jam, motor failure, etc.), the machine will continue to operate using the
other two hoppers.
IF AN ACCESS CODE HAS BEEN ESTABLISHED
A. The left two digits of the access code will be blinking. (This is the BC-3500’s way of indicating which
information will be changed if you make a change.) Press the
or
button to change the left two digits
of the four-digit access code.
The
and
buttons will allow the numbers 00 through 99 to appear in each of the two halves of the
four-digit security code.
B. When the display shows the correct two left-hand digits of the access code, press the VALUE button.
C. The right two digits of the access code will be blinking at this time. Press the
or
button until the
right two digits of the four-digit access code are correct.
D. When the display shows the correct two right-hand digits of the access code, press the VALUE button
and “LEVEL 1 ACCESS” will be displayed. (“LEVEL 0 ACCESS” will be displayed if the incorrect
access code is used, and you will be prompted to re-enter the access code.) You can now advance
to the setup functions that follow.
TO PROGRAM A DIFFERENT ACCESS CODE
A. If the access code is presently 0000, go directly to Step C which follows.
B. If a non-zero access code is currently in the computer, you must first enter that code as described in
the previous paragraphs. Then, using the FUNCTION button, advance through each of the setup and
audit functions until “PROGRAMMING ----” is again shown on the display.
C. Enter the desired access code using the
,
, and VALUE buttons as described in Step C and Step D
of the previous procedure. With the desired four-digit code showing on the display*, press and hold
the HOPPER button for about three seconds until the message “NEW CODE STORED” appears. The
new code has now been stored in the computer’s memory and will be the required access code the
next time the programming mode is entered.
* NOTE: DO NOT USE ANY CODES BEGINNING WITH 11XX – THESE ARE USED FOR
SPECIAL PURPOSES.
To Next Page
