BC-3500 Bill and Coin Changer
3-6 25238801
CHANGE BUCKET LUBRICATION
The coin dispenser change bucket door pivots, links, hubs and bell cranks are factory lubricated with light machine
oil. Rowe specification Number 00137900 oil or 3-in-1 Electric Motor Oil can be used. If change bucket is worn
beyond repair, order and install one of the kits listed at the end of the Parts Catalog in this manual.
For the most reliable performance, the lubrication should be renewed annually by applying one drop of oil at the points
shown in Figure 3-5.
Figure 3-5. Change Bucket Lubrication
TEST PROCEDURES
Checking a Bucket Solenoid
A solenoid that looks discolored or burned should be checked. Unplug the solenoid from the circuit before taking
any measurements. A good solenoid should measure approximately 8.5 ohms.
Transport Motor Speed Check
The BC-3500 transport motor speed and direction are computer controlled. No adjustments can be made, however
the encoder on the back of the motor can be checked. The computer detects pulses from this encoder for speed
control.
1. Be sure that the Anti-Pullback feature is disabled before performing this check!
2. Remove the transport from the machine, but keep it plugged in and keep the bill changer power ON.
To Next Page
