BC-3500 Bill and Coin Changer
2-22 25238801
4. If power is disrupted during a dispense or replenish cycle, the machine will immediately reset upon power
turn on. There will be an incorrect change load in one of the buckets. This is the same as all previous Rowe
changers.
5. If the changer runs empty while paying for a large bill directly from the hoppers, the display will be flashing the
appropriate message. Upon clearing the SHUTDOWN CODE for this empty condition the display will show
“
AMT DUE X Y Z” with X, Y, and Z being the number of coins or tokens that the customer was shorted from
the left, center, and right hoppers respectively.
6. Blocking the coin photodetectors with your fingers or with foreign objects during the replenish cycle may
result in wrong counts. If the detectors are blocked too long, the machine will shut down with a flashing error
message indicating which detector was blocked. If the wrong count is entered ,the display may show a
flashing message “
EXTRA COIN”. Either condition will put the machine in a shutdown mode.
7. Always turn the power OFF when removing circuit boards. Avoid touching the connectors when handling
these assemblies.
WARNING:
When the machine is turned on, there is 120 VAC voltage on the computer control board. If, for any
reason, this board is plugged in without its cover on, BE CAREFUL!
To Next Page
